PDA

View Full Version : Help with a Wiring Issue



Michael1
12-08-2012, 11:01 AM
Was hoping for a wiring diagram for a model 1500

I bought the smoker used and have used a few times but the wiring has burnt and I am doing a rewire for it now. Was hoping someone knew the schematic of the wiring....

Thanks for any help!

applejack
12-09-2012, 01:58 PM
Hello Michael1,

Have you talked with SmokinTex about this? Really great folks and the best qualified to offer advice. Suggest that you give them a call.

Best wishes for full recovery.

Jack

Idaho Jjoh
12-12-2012, 06:51 PM
Pretty simple. I hav rewired my 1400 a couple of times over the years. Take one wire from the power cord and connect it to one side of the heating element. take the other wire and run it up to one side of the t-stat. run a wire back down from the other connector on the t-stat to the other connector on the heating element. You have to take off the back panel to do all of this. Make sure you get the insulation back in place. Ususlly what causes the wiring to burn out is the insulation around the wiring doesn't cover properly.